6/28/2023 0 Comments 2010 wrx mishimoto radiator hoses![]() Use the large fitting for: 2010–2014 Subaru WRX, 2005–2009 Subaru Legacy GT/Outback XT, 2009–2013 Subaru Forester XT.įits all 2008-2014 manual-transmission WRX and 2008-2022 STI, plus manual-transmission 2005-2009 Legacy GT/Outback XT. Use the small fitting for: 2008–2009 Subaru WRX, 2008–2021 Subaru STI. For additional technical information, contact hose nipple fittings are provided. Mishimoto recommends that you check all connections at regular intervals, especially during the first few miles after installation. If the Mishimoto cap is fit on the radiator, overheating may occur. Due to the difference in construction, the Mishimoto cap cannot be used on the radiator. The Mishimoto radiator cap is a two-way valve, while the stock radiator cap is a one-way valve. The stock cap attached to the radiator should be installed on the Mishimoto radiator. Then my stock cap did not want to fit (as recommended by Mishimoto) and took a lot of effort to get it on. Caution: If you do choose to use the provided Mishimoto radiator cap, it should replace the stock cap located on the expansion tank. I had to cut both the hoses coming off the upper reservoir shorter, cut the upper radiator hose 1 inch shorter (radiator side) and cut the lower radiator hose 1 inch shorter (engine side). We prefer to use the OEM Subaru round cap. Note 2: The radiator comes with a Mishimoto radiator cap pre-installed. If you have an automatic transmission, you MUST use an auxiliary trans cooler to use this radiator. Note: This radiator is intended for manual transmission vehicles only. ![]() Core Size: 27.08" x 13.39"/688mm x 340mmĪdd on these OEM foam seals for better air managment.Mishimoto's all-aluminum radiators have strong aluminum end tanks that are immune to the problems of the stock plastic end tanks.
0 Comments
Leave a Reply. |